BEHost / Friday, July 8, 2022 / Categories: Technical - Cermark, Laser Marking, Laser Marking Tips, Laser Marking FAQ's Application of CerMark Ultra Paste How to apply CerMark Ultra Paste CerMark ULTRA is specifically formulated to laser mark on most laser markable substrates such as metals, glass, ceramics (glazed or unglazed), stone, brick (glazed & unglazed), slate and more using just one CerMark product. This new product is by far superior to our existing product line formulated to achieve the best results in the industry. CerMark ULTRA is ethanol based which allows for a faster drying time. Using CerMark ULTRA: Strengths of Product Allows CO2, YAG, and Fiber lasers to mark the follow substrates: Uncoated metals such as stainless, brass, aluminum and more as well as ceramics, glass, porcelain, brick and more. Produces high contrasting, highly durable marks; fast drying; will not stain sensitive metals such as brass, nickel and others. Recommended Application Parameters Application Methods Spray gun, airbrush, or aerosol. Application Clean the surface to be marked so that it is free of any lubricants or oils. The ULTRA must be applied with an even coat to ensure a consistent mark and color. Coverage 500 grams of the CerMark ULTRA will cover approximately 6000 square inches. Thin with ethanol. Recommended reduction 1:1 ratio by volume: 1 part ULTRA – 1 part ethanol Thinner Suggested Cleaning: Wash with water or a wet towel or sponge. Previous Article CerMark Ultra use Next Article Spirit GLS & GLSH Laser Parameters Print 653 Rate this article: No rating Please login or register to post comments.