Anonym / Friday, September 10, 2021 / Categories: Technical - GCC, Laser Tips, Laser Marking Tips, Laser Marking FAQ's FAQ - How do I use Adobe Acrobat reader DC to output to LaserPro products? How do I use Adobe Acrobat reader DC to output to LaserPro products? Note: For cutting jobs, the cutting line width should be 0.001mm (set to hairline is not enough). 1. Use Adobe Acrobat reader DC to open pdf files. Then click File/Print. 2. Select GCC LaserPro driver (in this case is Spirit 4.08-01) and then click properties (the red circle below). 3. Set the proper power and speed and other parameters and then click print. 4. Make sure that the Advanced tag has the settings seen in the attached article document. Previous Article FAQ - Should there be a gap at the joint of cutting lines after the mainboard is replaced? Next Article Ferro Product Update: Cermark LMM-6060 Marking spray is now discontinued. Print 515 Rate this article: No rating Tags: laser marking GCC Support Adobe LaserPro Documents to download FAQ_How20to20use20Adobe20Acrobat20reader20DC20to20output20to20LaserPro20products_V1.0(.pdf, 553.42 KB) - 11 download(s) Please login or register to post comments.