GCC Mercury I Parts

Air Nozzle, SmartAir Fine Nozzle For Mercury-All/X252/X380

Air Nozzle, Standard Air Assist for: All Mercury Series, X380RX, MG380H, X252 (LH01330)

Bearing, Single for Mercury\X252\X380\MG380\Venus, Right Side Pulley

Belt, X-axis Carriage Belt, Long-Open 69.4" for: Mercury\X252\Pennacle M-Series (2GT-1764-10)

 GCC 20600025G  Belt, Y-axis Carriage Belt, Long- Open For Mercury  (2GT-1294-12, 51"L)   

Cable, Auto Focus Cable, Braided-2S  For: Mercury-ALL, X252 (39" Long) HTS: 8466.93.9585

Cable, Laser to MCB BNC Cable, Mercury/GAIA I/II Laser (CN00178)

Cable, Parallel Communication Cable, MCB to Chassis Short 350mm, Mercury I

Cable, Rotary Connection Cable from Machine to Attachment PCB (155cm for Rotary Assy 29001051G and 290072190G)

Machine Model: Mercury/Spirits/S290 (Female)

(Connect from Main Board MCB-To-Rotary Attachment) 

Chain, X-Tube Chain Track for Mercury, X252, Houses AFCable & Air Line (07.10.018-23L-060.10.12)

Connector, Pipe, Air Assist Hose, M-5HLH-6 (Mercury, X-Series, Venus)

Cover, LED's Fluorescent Plastic Cover for Lamps (All Mach.)

24100170G Coverlid, Top Clear Acrylic Lid for Mercury I & II Laser 

(Window Only - No hinges)

Exhaust Port Wind Pipe Stable Seat 4” with Round Border (Mercury I, II, III, X252, X380)

Fan, 24Vdc Fan, Laser compartment (Mercury 1)

Filter, Air Compressor Vapor Filter, Explorer/Spirit

Filter, Electrical Power EMI Filter YE10T1L2 (Mercury's, Spirit's, X-Series)

Two (2) Plastic Flags
Machine Model: Mercury / X380

Two (2) Plastic Flags 
Machine Model: Mercury / X380

Flash ROM, EEPROMs SET with Odd\Even Chips (Mercury, Venus, J,L,JU)
* Firmware may be required to be loaded to EPROM by client.  Jorlink will offer this service if we have an identical machine at a cost of $90 + part.  Otherwise, client can loaded with our assistance over the phone\on-line at our hourly support rates, click here to order your support session.  

Fuse, 5-Amp Sensor PCB (LGCC-290090950G)

Fuse, Circuit Breaker (15A/250V ZE-800) for GCC Lasers (All Models)

Fuse, Circuit Breaker (3A/250V ZE-800) for GCC Lasers & Vinyl Cutters

Hinge, Window Lid Hinge for ALL GCC LaserPro Machines