Carriage, Lens Carriage Assembly w/o Lens and Mirror (Before SN: I50790), Spirit GX

Pointer, Red Pointer Diode Assembly, X252/X380/MG380 (for 5206e/5272v1/5272v2)
HTS#: 8456.11.0000

For GCC LaserPro X-Series Models X380, X252, MG-X380HYB

MCB, GCC Main Motherboard Type 5206E (Mercury III, New Mercury)

Tube, Laser Tube, 80w Glass Tube R-Type for GCC Laser Model: X252 
* w/1-Year Parts Limited Warranty  (Up to 50% Power)

Motor, X-axis (GCC Vinyl Cutter Puma II & III (132cm\52" Model)

* 3-Months Manufacturer's Warranty

(BK01359C, Hansen Motor 116-33224-)

Roller, Assist Roller Assembly for GCC Expert 24

Rear platen assembly (For service) for GCC Expert 24

Front platen assembly (For service) for GCC Expert 24

290068060G Panel, Control Panel Assembly for Jaguar II and IV (Without Watchdog) / The Watchdog is usually located on the side of the machine, where the white ribbon cable connects, the control panel and motor run through it.

29005256G - Watch Dog-Interface Converter Board Assembly, Jaguar II/III/IV (no watch dog for J5 series)

Control Panel, LCD Assy PCB for 5206e MCB (Spirits-All-Older, S290, C180-II, MIII, X252\X380\X500-II, Gaia)

Control Panel, LCD Assy PCB for 5206e MCB (C180-I)

LGCC-290069150G Lens, Dust Prevention Window Assembly

(Rectangular, 2nd Mirror Mount, C180-I, C180-II, Previous # 29005134G)

Mirror, #3 w/Holder for: X-500 Series 80w/100w Laser (After Serial #: M50355)

Lens Carriage Module(mirror 3 + holder) for80w/100w 

Mirror 4, 1" Dia. for: X380/X252/MG380Hybrid/Mercury SN before U90xxx/T90xxx, Venus II SN before T56191
Replaces LGCC-29001107
Base DIM's: 1.26"W x 1.35"H (32 x 34mm)

GCC 290069540G Lens, Collimating, Dust Prevention Window

Machine model: X380 / X500 - II & III

Lens 2" FD-Blue, Std For Models: Mercury-ALL\Venus-II\X252\X380\MG380-HYB Spot Size: .005"

For Machine from Serial #: Mercury-ME-25/ME-40V SN before T90xxx, ME-12/ME-30V/ME-40Vi/ME-60Ti SN before U90xxx, X252, X380, MG380Hybrid SN before U90xxx, Venus II SN before T56191

PCB, High Voltage Control Board Set for CDGRI & Reci for X252-80w \ X380-100w \ X500-100w+
(Replaces PCB # 29006036G)

290070600G - 2 in 1 Cutter mainboard with Puma II (PLUS) firmware 

Rail, X-axis Linear Guide with Bearing Block ONLY (Spirit SGLS)