Panel Board 2 Right Side EGX-20, Knob Adj. Control (#33 Image)

RR31049175AS Screw, wire pin locking screw (M4*20 NI) EGX350

Roland Notes: This machine has been discontinued

Spindle, Roland EGX20, 1/8" Assy. (90 Day Warranty)

Spindle, Roland EGX400/600, 1164" Assy. w/o Collet or Micrometer (90 Day Warranty)

Note: After you replace the spindle, you need to run it without any load with no tool or collet installed for approximately 20 minutes at 15000-RPM

Switch, Cable-Assy, Cover SW1 EGX360

Switch, Cable-Assy, Cover SW2 EGX360

Switch, Emergency Stop Cable-Assy EMG EGX400 / EGX600

Switch, Z-Axis Cover, Z-axis Limit & X-axis Limit, Cable Assembly Sensor, EGX400\600

Table, EGX30A & EGX30, Surface Table Flat

This T-Slot Table (Product # ZTT-35) is an optional accessory for use with third party vises and fixture. This table is compatible with the EGX-350 an DE3

Table, Vacuum Table (Product # ZV-23A) is an optional accessory for use with the Chip Extraction System (Product #US-CHIPSYS-C). This table is used as an alternative to adhesive sheets for holding down flat plastic material and is compatible with the EGX-350 engraver

Instructions

Tray, Water Tray Cleaner Box for Roland EGX360

Vacuum Adapter For Roland EGX400\600, ZAD-600
This Vacuum Adapter (Product #ZAD-600) is to connect the machine to the hose of the vacuum. This item is included in the Chip Extraction System (US-CHIPSYS-C). This adapter is for use with the EGX-400/600 engravers.

Vacuum, Chip Extraction Sys. UltraQuiet, 1/2hp w/accumulator

Key Features

• This chip removal system is quiet and efficient to use in any shop.
• The vacuum not only keeps your works space clear of debris, but it also filters 99.99% of dust out of the air!
• The systems are also self-contained so it can be used to reclaim precious metals.
• The vacuum hose supplied slips onto the vacuum connection on top of the unit and the other end connects to the collection device desired.
• The ideal location for the US-CHIPSYS-C is under the bench where the user works.

US-CHIPSYS-C Specifications

• Usage: Single station use for collecting dust at 1.5” diameter workstation
• Speeds: Single Speed
• Size: 14.Lx10.Wx12.H
• Power Requirement: 115 VAC 5A
• Overload Protection: Resettable circuit breaker included.
• Sound rating: 53db on High
• Dust Collection: Collects 99.99% of all dust (filter rated at 95% @ 1 micron)
• Motor Rating: High-Performance ½ Horsepower Motor

Vise, Fixture Kit (Vise, Pin Jig, Pen Fixture, Ruler Bar Fixture, 2 Medallion/Seal Fixtures) For: EGX-300/350/360/400/600

Vise, Machine Center Vise (PNC-2300/EGX-300/EGX-350)

Wire, X-Axis CS-20 EGX30 (ea, 1 on Machine)

Wire, X-axis EGX350 1000003234

Roland Notes: This machine has been discontinued

Wire, X-Axis PNC2300A\EGX300

Wire, Y-Axis CS-20, EGX30 (ea., 2 on Machine)