Ferro Product Update: Cermark LMM-6060 Marking spray is now discontinued. Recommended replacement is Cermark LMM-6000 Marking Spray. Anonym / Friday, October 1, 2021 0 678 Article rating: No rating Ferro Product Update: Cermark LMM-6060 is now discontinued. Ferro’s recommended replacement for the LMM-6060 is Cermark LMM-6000. Click Here new to learn more about LMM-600! Read more
FAQ - How do I use Adobe Acrobat reader DC to output to LaserPro products? Anonym / Friday, September 10, 2021 0 764 Article rating: No rating How do I use Adobe Acrobat reader DC to output to LaserPro products? Note: For cutting jobs, the cutting line width should be 0.001mm (set to hairline is not enough). 1. Use Adobe Acrobat reader DC to open pdf files. Then click File/Print. 2. Select GCC LaserPro driver (in this case is Spirit 4.08-01) and then click properties (the red circle below). 3. Set the proper power and speed and other parameters and then click print. 4. Make sure that the Advanced tag has the settings seen in the attached article document. Read more
FAQ - Should there be a gap at the joint of cutting lines after the mainboard is replaced? Anonym / Friday, September 10, 2021 0 691 Article rating: No rating Should there be a gap at the joint of cutting lines after the mainboard is replaced? The cause is that the laser tube model is not correctly set. A default laser tube model will be set in the firmware (mainboard) before GCC ships the mainboard to the customer. The default laser tube model might be different if the board is replaced on a customer’s machine - it might need to be modified. Modifying the laser tube model: Read more
FAQ - Will it shorten the life time of my laser tube if the power setting is at 100%? Anonym / Friday, September 10, 2021 0 703 Article rating: No rating Will it shorten the lifetime of my laser tube if the power setting is at 100%? THIS IS A MISCONCEPTION! Perhaps you will feel that setting the laser tube at its power limit (power set to 100%) might bring negative consequences, especially in regards to the lifetime of laser tube. Indeed, for most industrial products this critical operation might shorten its service life. However, we have to realize one thing first - for a laser tube, outputting at a 100% level is not a kind of critical operation, too high of an unstable current is. While the power supply of the laser tube is outputting a regular and stable current to the laser tube, no matter which power level you are using, it won’t affect the service time of the tube even if you set the power level at 100% in the driver. Read more
FAQ - Does the purity of air (Oxygen or Nitrogen) affect the laser cutting quality? Anonym / Friday, September 10, 2021 0 691 Article rating: No rating Does the purity of air (Oxygen or Nitrogen) affect the cutting quality? Based on internal testing, higher purity levels result in higher cutting quality. Downside to this is that the cost of higher purified air is more costly. We suggest Oxygen purity of 99.8%(2N8) or higher. The purity of Nitrogen should be 99.995% (4N5) or higher. Read more