Laser Marking FAQ's

Question- Can I get blacker marks with a thicker coat of LMM-6000 & LMM-14?

Answer- No. Additional LMM-6000 & LMM-14 film thickness will only result in more power being needed to make a mark; it will not make the marks any darker.

How do I use Adobe Acrobat reader DC to output to LaserPro products?

Note:
For cutting jobs, the cutting line width should be 0.001mm (set to hairline is not enough).

1. Use Adobe Acrobat reader DC to open pdf files. Then click File/Print.

2. Select GCC LaserPro driver (in this case is Spirit 4.08-01) and then click properties (the red circle below).

3. Set the proper power and speed and other parameters and then click print.

4. Make sure that the Advanced tag has the settings seen in the attached article document.

Does the purity of air (Oxygen or Nitrogen) affect the cutting quality?

Based on internal testing, higher purity levels result in higher cutting quality. Downside to this is that the cost of higher purified air is more costly.
We suggest Oxygen purity of 99.8%(2N8) or higher.
The purity of Nitrogen should be 99.995% (4N5) or higher.