CerMark Ultra - The Do-It-All Laser Marking Material CerMark Ultra product and sales BEHost / Friday, October 29, 2021 0 855 Article rating: No rating CerMark Ultra - The laser marking material that works on almost everything! CerMark Ultra is formulated to produce a black mark on metals, glass, ceramics, stone, brick, slate, and more. Available in paste or spray. Products Read more
Linx High Speed Production Lasers and Integration Services Linx makes high capacity laser marking possible BEHost / Monday, October 25, 2021 0 748 Article rating: No rating Read more
Ferro Product Update: Cermark LMM-6060 Marking spray is now discontinued. Recommended replacement is Cermark LMM-6000 Marking Spray. Anonym / Friday, October 1, 2021 0 644 Article rating: No rating Ferro Product Update: Cermark LMM-6060 is now discontinued. Ferro’s recommended replacement for the LMM-6060 is Cermark LMM-6000. Click Here new to learn more about LMM-600! Read more
FAQ - How do I use Adobe Acrobat reader DC to output to LaserPro products? Anonym / Friday, September 10, 2021 0 704 Article rating: No rating How do I use Adobe Acrobat reader DC to output to LaserPro products? Note: For cutting jobs, the cutting line width should be 0.001mm (set to hairline is not enough). 1. Use Adobe Acrobat reader DC to open pdf files. Then click File/Print. 2. Select GCC LaserPro driver (in this case is Spirit 4.08-01) and then click properties (the red circle below). 3. Set the proper power and speed and other parameters and then click print. 4. Make sure that the Advanced tag has the settings seen in the attached article document. Read more
FAQ - Should there be a gap at the joint of cutting lines after the mainboard is replaced? Anonym / Friday, September 10, 2021 0 634 Article rating: No rating Should there be a gap at the joint of cutting lines after the mainboard is replaced? The cause is that the laser tube model is not correctly set. A default laser tube model will be set in the firmware (mainboard) before GCC ships the mainboard to the customer. The default laser tube model might be different if the board is replaced on a customer’s machine - it might need to be modified. Modifying the laser tube model: Read more